The right fence depends on your boundary, your security level and your budget. The main types we install:

A complete, compliant installation is far more than strands on brackets. Done properly it includes:

The energiser is rated in joules, and the rating has to match the length of fence it drives. Fit a unit that is too small for a long perimeter and the shock fades before it reaches the far end, leaving part of the fence under-powered no matter how well the rest is built. We calculate the load — total wire length across all strands and zones — and specify an energiser with the headroom to drive it to a proper, even shock, with capacity to spare for future extension.

We also choose the power configuration to suit the site: mains with battery backup for most properties, or a solar energiser for sites badly affected by load shedding or without convenient mains, which runs off its own panel and battery and avoids the mains-restoration surge entirely.

A new electric fence installation in South Africa carries legal obligations, and a proper installer builds to them. The system must comply with the relevant standards — SANS 10222-3 and SANS/IEC 60335-2-76 — covering how the fence is constructed, its clearances and heights, and its safety. Compliant warning signage must be displayed at intervals along the fence and at gates. And critically, a new installation requires an Electric Fence System Certificate of Compliance, which only an installer registered with the Department of Employment and Labour may issue.

This matters beyond box-ticking. An installation that is not built to standard and not certified can leave you unable to satisfy a property transfer later, can complicate insurance claims, and carries liability if someone is harmed by a non-compliant fence. We build to the standards and provide the COC on handover, through a registered installer, so your new fence is compliant from the day it goes live.

Electric fencing attracts bargain operators, and the savings are usually illusory. The corners that get cut are the ones you cannot see on handover: too few or too shallow earth stakes, so the fence reads voltage but never really shocks; an undersized energiser that fades at the far end; cheap insulators and ungalvanised wire that corrode and fault within a season; no surge protection, so the first storm kills the energiser; and no genuine Certificate of Compliance, which surfaces as a problem only when you try to sell.

A proper installer assesses the site, sizes the system, uses quality components, earths it correctly, protects it against surges, certifies it through a registered installer, and guarantees the work. It costs a little more upfront and far less over the life of the fence. When you compare quotes, compare what is actually being installed — earthing, energiser rating, component quality and certification — not just the headline price.

No single factor damages electric fences in Johannesburg more than the power situation, and it is worth understanding because it shapes both why fences fail and how to protect them. During an outage, a mains energiser switches to its backup battery and the fence keeps pulsing — exactly as designed. The damage comes not during the outage but at the moment power is restored, when the grid often returns with a voltage spike. That surge travels into the energiser's power-supply stage and, on a board with no surge protection, punches straight through sensitive components.

This is why so many energiser failures appear in the hours after the lights come back on, and why a unit can survive many outages and then die on one. There is a slower, parallel cost too: every deep discharge during a long outage ages the backup battery faster than its rated two-to-three-year life, so heavy load shedding tends to wear out the battery and stress the board on overlapping timelines, producing dead fences, beeping and false alarms.

The defences are inexpensive relative to the damage they prevent: a surge protector on the supply, an intact and correctly-earthed lightning diverter, and, for properties that keep losing units, conversion to a solar energiser that runs off its own panel and battery and never sees the mains spike at all. We fit surge protection as a matter of course on board replacements, because protecting the repair is part of doing it properly.

Not every electric fence fault is an emergency, and knowing the difference helps you act sensibly. If you have found a cut or pulled-down wire, treat it as a possible intrusion attempt: alert your armed-response company first, keep people and pets away from any loose, possibly-live strand, and call us to repair and re-test — including confirming the alarm actually reached your monitoring. If the fence is simply dead, weak, beeping or nuisance-alarming with no sign of tampering, it is not a 999 situation, but it does mean your perimeter is compromised, so it is worth sorting quickly rather than living with it.

Either way, do not try to investigate the high-voltage side yourself — no touching the wires, no opening the energiser. The safe, useful things you can do are all observation: note the symptom precisely, when it started, and whether it follows a pattern (after a power cut, only in rain, only at night). If you can do so safely from the ground, a quick photo of the energiser's display and of anything obviously wrong on the line is genuinely helpful.

Then call or WhatsApp us for a free telephonic diagnosis. With the brand of your energiser, its status light or screen message, and the symptom pattern, we can usually tell you the likely cause and an honest price range before we travel, and bring the right parts on the vehicle. Close to our Broadacres base that often means a same-day, single-visit fix; further out we will give you an honest planned time. The two minutes you spend describing it accurately is what turns a repair into a one-visit job.

An electric fence is a high-voltage system. A healthy energiser delivers a pulse of several thousand volts, and while the design is intended to deter rather than injure a healthy person, the high-voltage side is not something to probe, open or repair without the right knowledge and equipment. The safe checks we suggest are deliberately limited to things you can do without touching the wires or opening the unit — looking, listening and noting — precisely because everything beyond that belongs with a technician.

There is a second reason beyond personal safety: a fence worked on incorrectly can be left non-compliant, under-performing, or falsely reassuring. A botched earth, a wrong-rated energiser, a join that becomes a short, or an alarm output left disconnected can all leave a fence that looks fine and protects nothing. We carry the test equipment to diagnose properly, the stock to repair in one visit, and the knowledge to leave the system both safe and genuinely working — backed by a six-month guarantee, which a DIY attempt cannot give you.

Every job starts with a free telephonic diagnosis. Tell us the symptom — the pattern of the alarm, the status light, whether the fence is dead or weak — and we will give you the likely cause and an honest price range before anyone drives out, so there are no surprises. The call-out is from R450 and is waived when you proceed with the repair.

On site, we diagnose with proper test equipment rather than swapping parts and hoping: open-circuit output at the energiser, earth-return voltage, and directional fault-finding along the line. We repair before we replace, and where a replacement is genuinely the better value we say so and explain why on the numbers, never on pressure. Because we carry the common stock on the vehicle, most faults are fixed in a single visit.

Then we re-test the whole system — output, earth and the alarm — so you leave with a fence that shocks properly and warns you if it is breached, not just one that has had its immediate symptom silenced. Every repair carries a six-month guarantee, and you deal directly with our team throughout: no call centres, no commission-driven upselling.

Electric fence faults do not respect property type, and neither do we. On freestanding family homes the typical work is vegetation shorts, cracked insulators, surge-damaged energisers and tired batteries, fixed quickly and guaranteed — the bulk of everyday residential call-outs sit here.

On townhouse complexes and estates the systems are usually multi-zone, so a fault can be isolated to one section without dropping the whole perimeter, and the Certificate of Compliance for common-property fencing is generally the body corporate's or homeowners' association's responsibility — so we coordinate with the managing agent and report properly. A maintenance contract often makes sense at this scale.

On commercial and industrial premises, detection matters as much as deterrence: the priority is that the fence genuinely alarms to monitoring or armed response when it is breached, and that the work is documented for insurers. We verify the alarm output, integrate with alarm panels where needed, and service to scheduled windows so cover is never down during operating hours. Whatever the property, the same honesty, testing and guarantee apply.

If you are selling your property, or you have installed, altered or replaced the energiser, you may need an Electric Fence System Certificate of Compliance. It is a separate certificate from the ordinary electrical COC, it is required for property transfers and for new or altered installations, and only an installer registered with the Department of Employment and Labour may issue one — confirming the system meets SANS 10222-3 and SANS/IEC 60335-2-76.

Routine minor repairs such as replacing wires, insulators or bobbins do not trigger a new certificate, but replacing the energiser does, because it materially changes the system. We will tell you honestly which applies to your situation, and can arrange certification through a registered installer. This is general guidance, not legal advice — for a property sale, confirm the current requirements with your conveyancing attorney.